基于矩阵的C4ISR系统结构设计评价

主要目的是提出两种矩阵方法对C4ISR系统结构进行评价.其中邻接矩阵法用于评价C4ISR系统之间的互连互通性,对于评价规模较大、结构复杂的系统结构较为适用;模糊矩阵法用于评价系统之间的相似性,通过科学的评价指标体系消除系统之间的冗余.这些方法是当前主流的经验评价方法(如ATAM方法)的有效补充,具有一定的科学性和合理性.最后分别给出了两种方法的一个应用实例,体现了其在工程实践上的价值.     

基于PON技术的多站雷达数字光纤传输系统设计

提出一种多站雷达体系雷达数据光纤传输系统的方案设计和实现方法。与传统雷达使用的光纤传输系统不同,而是采用技术较新的基于无源光网络PON的实时数据通信系统,这是无源光网络技术在多传感器实时通信领域的首次应用。在系统设计中利用先进的光电子和在编程技术,实现了点对多点雷达数据光纤传输,提高了信号传输质量,同时系统具有动态接入和扩容的能力。     

Transient analysis of Markov models of fault‐tolerant systems with deferred repair using split regenerative randomization

The (standard) randomization method is an attractive alternative for the transient analysis of continuous time Markov models. The main advantages of the method are numerical stability, well‐controlled computation error, and ability to specify the computation error in advance. However, the fact that the method can be computationally very expensive limits its applicability. In this paper, we develop a new method called split regenerative randomization, which, having the same good properties as standard randomization, can be significantly more efficient. The method covers reliability‐like models with a particular but quite general structure and requires the selection of a subset of states and a regenerative state satisfying some conditions. For a class of continuous time Markov models, model class C₂, including typical failure/repair reliability‐like models with exponential failure and repair time distributions and deferred repair, natural selections are available for both the subset of states and the regenerative state and, for those natural selections, theoretical results are available assessing the efficiency of the method in terms of “visible” model characteristics. Those results can be used to anticipate when the method can be expected to be competitive. We illustrate the application of the method using a large class C₂ model and show that for models in that class the method can indeed be significantly more efficient than previously available randomization‐based methods. © 2006 Wiley Periodicals, Inc. Naval Research Logistics, 2006     

整环上不定方程组的通解公式及其应用

借助Z上矩阵A∈Mm×n(Z)的标准形式D=VAU=diag(d1,d2,…,dq,0,…,0),得到了整环上不定方程组AX=B的通解公式以及矩阵初等变换法.     

L波段掺铒光纤放大器增益钳制及提高特性研究

报道了一种新型980 nm激光二极管(LD)泵浦高增益的掺铒光纤放大器(EDFA).通过加入中心波长为1 550 nm光纤光栅(FBG)可以明显提高增益,并分析了增益钳制的原理.实验得到其增益比无FBG结构EDFA提高8 dB,并得到了小信号输入时增益25 dB的有效钳制.     

基于时滞分割法的具有leakage项时滞的离散型神经网络状态估计

摘要：研究一类具有leakage时滞的离散型神经网络的状态估计问题．通过构造新的Lyapunov泛函得到保证估计误差全局渐近稳定的充分条件,并通过求解一个线性矩阵不等式（LMI）得到状态估计器的增益矩阵．采用一种新的时滞分割方法将变时滞区间分割为多个子区间,使该结果在获得更小的保守性同时也降低了计算的复杂度．     

GPS接收信号中线性扫频干扰的抑制

研究了阵列接收的GPS接收信号中线性扫频(LFM)干扰的抑制问题。LFM信号瞬时频率的估计是抑制干扰的关键,而要准确估计信号瞬时频率,必须抑制接收信号时频分布中交叉项干扰。本文对接收信号矢量进行白化,得到信号矢量白化后的空时频分布(STFD)矩阵。文中推出一个与传统方法获得的判决变量不同的判决变量,用该判决变量可以更加清晰地选出LFM信号在时频分布中的自项。根据时频脊点的分布估计LFM信号频率参数以及信号瞬时频率,之后即可根据瞬时频率构建陷波器滤除干扰。仿真表明该方法能够将受交叉项严重干扰的接收信号时频分布映射为清晰的接收信号自项的时频分布,在数据快拍数满足一定要求时可以很好地抑制掉LFM干扰。     

利用径向力平衡飞行控制的航天器高精度轨道捕获方法

为实现对探测器轨道形状与高度的精准调整,提出一种径向力平衡飞行的航天器连续推力控制新方法。建立连续推力平衡飞行的动力学极坐标模型,并推导出特殊条件下的解析轨道解,进一步分析边值条件,给出连续推力的控制律。利用这一平衡飞行控制理论,构建轨道捕获的最优控制策略。考虑推力器的推力水平,通过一次或多次的控制过程,实现对轨道形状、轨道高度及轨道相位的综合调整。数值仿真表明:利用平衡飞行的轨道控制方法,配置微小推力器的空间引力波探测器可以实现高精度的轨道捕获;该方法具有控制过程可解析、计算量小、简便、实用等特点。     

结合流形滤波的矩阵信息几何检测器

针对小样本、非均匀杂波下的信号检测问题,提出一种基于流形滤波的矩阵信息几何检测器,将信号检测问题转化为矩阵流形上的几何问题。将每一个样本的相关性数据建模为一个托普利兹正定矩阵,在此基础上,利用每一个样本数据的邻近矩阵进行加权平滑滤波,去除一部分杂波能量,提升目标与杂波间的区分性。计算了辅助样本数据对应矩阵的几何均值,通过比较待检测样本数据矩阵与几何均值矩阵之间的距离与检测门限的大小,以实现信号检测。实验结果表明,与自适应匹配滤波相比,本文方法在小样本、非均匀杂波下具有明显的性能优势。     

Investigation of the mechanical and ballistic properties of hybrid carbon/ aramid woven laminates

High-performance ballistic fibers, such as aramid fiber and ultra-high-molecular-weight polyethylene (UHMWPE), are commonly used in anti-ballistic structures due to their low density, high tensile strength and high specific modulus. However, their low modulus in the thickness direction and insufficient shear strength limits their application in certain ballistic structure. In contrast, carbon fiber reinforced epoxy resin matrix composites (CFRP) have the characteristics of high modulus in the thickness direction and high shear resistance. However, carbon fibers are rarely used and applied for protection purposes. A hybridization with aramid fiber reinforced epoxy resin matrix composites (AFRP) and CFRP has the potential to improve the stiffness and the ballistic property of the typical ballistic fiber composites. The hybrid effects on the flexural property and ballistic performance of the hybrid CFRP/AFRP laminates were investigated. Through conducting mechanical property tests and ballistic tests, two sets of reliable simulation parameters for AFRP and CFRP were established using LS-DYNA software, respectively. The experimental results suggested that by increasing the content of CFRP that the flexural properties of hybrid CFRP/AFRP laminates were enhanced. The ballistic tests’ results and the simulation illustrated that the specific energy absorption by the perforation method of CFRP achieved 77.7% of AFRP. When CFRP was on the striking face, the shear resistance of the laminates and the resistance force to the projectiles was promoted at the initial penetration stage. The proportion of fiber tensile failures in the AFRP layers was also enhanced with the addition of CFRP during the penetration process. These improvements resulted in the ballistic performance of hybrid CFRP/AFRP laminates was better than AFRP when the CFRP content was 20 wt% and 30 wt%.